Embedded Files
An interactive LED display screen is fascinating!
Every movement of step will result in the change of display content.
The installation process begins with the setting up of the footings, of course, prior to that, a careful measurement of the job site must be done, so that a proper size and quantity of LED tiles can be selected.
A single piece of LED tile
A single piece of LED tile
500 x 500 mm
Multiple tiles combined together to build a screen
Multiple tiles combined together to build a screen
The basic display unit is the module, typically 250x250 mm insize, 4 or 8 modules to make a cabinet.
The basic display unit is the module, typically 250x250 mm insize, 4 or 8 modules to make a cabinet.
A cabinet, whether consisting of 4 or 8 modules, must have power supply, which converts 110/220 VAC to DC 5V to supply the LED modules, a receiving card, which receives signal from sending card and transfer to modules, cables for power and signals must be included as well.
The upmost part of the module is the cover, as a tile, the cover must be as hard as a porcelain tile, anti-scratch, anti-slip, transparent but not glaring, water-proof, etc.
Now, the cover is made of treated polycarbon (PC), 10 mm of thickness, snapped into the bottom case.
The PC case covers the entire module for water-proof
The PC case covers the entire module for water-proof
Single module
Single module
The side with the LED arrays must be water-proof
Front of the PCBA
Front of the PCBA
Back of the PCBA
Back of the PCBA
The PCBA is screwed into the cabinet, leaving the sockets for power and signal connectors.
The PCBA is screwed into the cabinet, leaving the sockets for power and signal connectors.
Connecting cables of DC 5V and signal cables with the control box, before screwing the control box to the cabinet.
Connecting cables of DC 5V and signal cables with the control box, before screwing the control box to the cabinet.
The control box is ready to assemble, the AC cable is water-proof, plug and play.
The control box is ready to assemble, the AC cable is water-proof, plug and play.
Then it's good to go final installation, there are multiple ways of installation
Height is adjusted from the footings
Height is adjusted from the footings
Adjacent cabinets are connected by footings
The footing is made of steel,with rubber pad at the bottom
Sideview of the installed LED floor tile
A ventilation fan is placed beneath the tile
Installation almost done
Models available
We can advise on how to design, source and install a LED floor display. Any inquiries, please contact us: jeff.mrled@gmail.com
Page updated
Google Sites
Report abuse